A belt drive offers many advantages compared to traditional chain drives, such as less maintenance and a longer service life. However, to ensure that your belt drive can take full advantage of these benefits, regular cleaning and maintenance is essential. Here are some simple steps you can incorporate into your daily routine to keep your belt in top shape:
Step 1: Checking the belt
Before you start cleaning, you should check the belt for wear and damage. Look for cracks, cuts or frayed areas. If you notice such damage, it may be time to replace the belt to ensure optimum performance and safety.
Step 2: Cleaning the belt
For daily cleaning, it is sufficient to rinse the belt with clear water. Use a soft sponge or cloth to carefully remove dirt and deposits. Avoid using aggressive cleaning agents, as these can damage the belt material.
Step 3: Drying
After cleaning, you should dry the belt thoroughly with a clean cloth. Then allow the belt to air dry completely before using the bike again. Moisture can shorten the service life of the belt and should therefore be avoided as far as possible.
Step 4: Check voltage
Correct belt tension is crucial for good performance. A belt that is too loose can slip, while a belt that is too tight can lead to premature wear. Check the belt tension regularly and adjust it if necessary. You can find the correct tension in your MOUGG user manual or on the MOUGG website.
Step 5: Checking the alignment
Correct alignment of the belt ensures that it runs evenly over the pulleys. Incorrect alignment can lead to uneven wear and reduced efficiency. Check the alignment regularly and correct it if necessary.
By incorporating these simple steps into your daily routine, you can extend the life of your belt and ensure optimum performance from your MOUGG.
